HYOSUNG XRX125sm Owner's Manual page 67

◉ ◉ EXTERNAL
∙Spray all vinyl and rubber parts with
rubber protectant.
∙Spray the unpainted surfaces with rust
preventative.
∙Coat the painted surfaces with car wax.
◉ ◉ MAINTENANCE DURING STORAGE
Once a month, recharge the battery. The
standard charging rate is 0.6A × 10 hours.
★ ★ PROCEDURE FOR RETURNING
TO SERVICE
1. Clean the entire motorcycle.
2. Reinstall the battery.
N O T E
Be sure connect the positive terminal
first, then connect the negative
terminal.
3. Adjust the pressure of tires as described
in the TIRE section.
4. Lubricate all places as instructed in this
manual.
5. Perform the INSPECTION BEFORE
RIDING as listed in this manual.
CLEANING PROCEDURE
A thorough cleaning of your motorcycle is
a necessary part of maintenance and will
help keep your motorcycle looking and
performing its best. Proper cleaning can
also extend the life of your motorcycle.
It is important to clean and inspect your
motorcycle after every ride if it is used in
mud, brush, grass, water, salt water, or very
dusty conditions.
The build-up of mud, brush, grass, etc,
especially on the engine and exhaust
system, can reduce engine cooling, conceal
damage, or increase wear of certain parts. It
is important to remove all debris during
cleaning.
★ ★ PREPARATION FOR CLEANING
Block or seal the end of the exhaust pipe
(muffler) using a piece of plastic wrap, cloth
rag or another method to prevent water
from entering the engine.
High pressure washers can damage
your motorcycle. (especially the oil
cooler pin)
High pressure washers such as those
found at coin-operated car washes have
enough pressure to damage the parts of
your motorcycle. It may cause rust,
corrosion and increase wear.
Do not use high pressure washers to
clean your motorcycle.
66
CAUTION