HYOSUNG XRX125sm Owner's Manual page 62

LAMP
WARNING
Keep fuel and other flammable
substances away from electric
components.
CAUTION
Before changing a bulb, set the
ignition switch to position "OFF" and
allow a few minutes for the bulb to
cool down.
Wear clean gloves or use a clean, dry
cloth to handle the new bulb.
Do not put your fingerprints on the
bulb, as this may lead to overheating
and failure.
If you have handled the bulb with bare
hands, clean it with alcohol to avoid
any damage.
DO NOT PULL ON THE WIRES.
N O T E
Before changing a bulb, check the
fuses.
◉ ◉ INSPECTION OF LAMPS
● Check if the head lamp, position lamp,
tail lamp, meter lamp and license plate
lamp work well when the light switch is
operated.
● Check if the brake lamp work well when
the front brake lever or rear brake pedal
was squeezed or pressed.
● Check if the turn signal lamp work well
when the turn signal switch was
operated.
● Check if the head lamp, tail lamp, turn
signal lamp and brake lamp are dusty or
damaged.
◉ ◉ REPLACEMENT OF THE LAMP
Requirement electric power of the lamp
shown in the following chart.
When replace the damaged lamp, always
use the equal capacity.
The use of a lamp other than rules may
cause excessive voltage at the electric
system or damage the lamp.
NAMES
Head
LO
lamp
Position
Brake / Tail lamp
Turn signal lamp
License plate lamp
61
CAPACITY
12V-60W× 1
HI
12V-55W× 1
12V-5W× 1
12V-21/5W× 1
12V-10W× 4
12V-5W× 1