HYOSUNG XRX125sm Owner's Manual page 58

CAUTION
After replaced the rear brake pads, the
brake pedal depress and release several
times so that it is setting at the original
place.
Then, do not ride the motorcycle untill
operating the brake fluid and becoming
the brake distance.
● ● BRAKE DISK INSPECTION
Check the brake disk for damage or
cracks.
● ● REAR BRAKE FLUID SUPPLY
1. Place the motorcycle on a level surface
and keep the handlebars straight.
2. Clean the brake fluid reservior around not
to allow dust to get inside of it.
3. Turn the cap for counter-clockwise and
open the cap.
4. Replenish with brake fluid to the upper
line.
CAUTION
Do not spill any brake fluid on painted or
plastic surfaces as it will damage the
surface severely.
N O T E
The recommended brake fluid : DOT4
5. Fasten the cap.
● ● REAR BRAKE LAMP SWITCH
The rear brake lamp switch is located at
right-side of the engine.
Move the switch up or down to adjust it
until the switch operates and turns on the
brake lamp after the brake pedal begins to
be depressed.
◉ ◉ REAR BRAKE (For
● ● REAR BRAKE ADJUSTMENT
WARNING
Too much clearance in the rear brake
pedal can cause poor braking
performance and may lead to an
accident. Too little clearance may force
brake shoes to rub against the drum at
all times, causing damage to the shoes
and the drum.
Follow the steps in this section to adjust
the rear brake pedal properly.
Adjust the free travel
(0.79 ~ 1.18 in) by screwing in or out the
brake adjusting nut
57
�
�
①
to 20 ~ 30 mm
②
.
)
�