Marquis SPIRIT Operating And Troubleshooting Manual page 7

SETTINGS
–
TEMP-
–
TEMP-
+
TEMP+
PAGE 44
MARQUIS SPAS
spa control operation
Use the TEMP- pad to scroll through filter cycle
options. When desired selection has been reached,
press the SETTINGS pad to enter selection and
advance to the smart logic settings.
Selectable Filter Cycles and Cycle Duration:
• 2C: twice per day (once every 12 hours)
• 1Cd: once during the day
• 1Cn: once during the night
• FC1: 45 minutes
• FC2: 2 hours
• FC4: 4 hours
• FC6: 6 hours
SMART LOGIC
Since a spa is always covered when not in use, it
stays fairly free of debris or outside contamination.
Contamination to a spa's water occurs during usage,
so filtering immediately after usage is the most
effective time to clean the spa water. Your spa is
preset at the factory with a default setting to filter for
one hour (SL1) every time your spa is used. This
filtration cycle begins 30 minutes after the spa light or
jet pump has been deactivated. The pump runs on
low-speed to filter the water for the cycle's duration.
Selectable Smart Logic Settings
• SL1: 1 hour
• SL2: 2 hours
• SL3: 3 hours
• SL4: 4 hours
• SLO: Off
To Adjust the Smart Logic Settings:
Use the TEMP- pad to scroll through options. When
desired selection has been reached. Press SET-
TINGS pad to enter selection and exit settings mode.
TEMPERATURE DISPLAY AND ADJUSTMENT
Factory Default Settings:
• Temperature: 102°F (39°C)
The LCD window displays the actual water tempera-
ture. Pressing the TEMP+ pad makes the numbers
flash, then pressing the pad again (repeatedly)
increases the set temperature one degree at a time,
up to 104°F (40°C). After a short pause, the actual
temperature displays. Press TEMP- pad repeatedly
to decrease the set temperature to 80°F (27°C).