Marquis SPIRIT Operating And Troubleshooting Manual page 36

Tri-Zone control must
be "open" to the jets
you are vacuuming, in
this case, the upper
and mid back jets.
PAGE 73
MARQUIS SPAS
maintenance
SUSPENDED USE OR WINTERIZING THE SPA
Your spa was designed for year-round use and many
people find the combination of hot water, therapy
jets, and cool winter temperatures to be especially
soothing. However, if you decide to discontinue the
use of your spa for any extended period of time, we
suggest you follow the steps below.
NOTE: During long periods of inactivity, damage can
occur to equipment from condensation within the
equipment compartment.
1. Turn off the power to the spa.
2. Drain the spa. (See DRAINING AND REFILLING
THE SPA.)
3. Remove all residual water from the seating and
footwell. If necessary, bail out the remaining
water then dry the spa with towels. A wet/dry
vacuum is recommended for best results.
4. Using the wet/dry vacuum, place vacuum
nozzle over each jet nozzle to remove water
from plumbing lines, starting with the highest jet
and finishing with the lowest jet.
NOTE: The spa is equipped with a Tri-Zone
control which is used to divert water between
different jet zones. The valve must be "open"
to the particular jets you are vacuuming.
5. Unscrew the pump plug(s) from the pump(s) or
disconnect the freeze protection line. (See
STARTING YOUR SPA.)
6. Again, using the wet/dry vacuum, place nozzle
over the exposed pump opening(s) to remove
excess water. The pump(s) should be re-
moved from the spa and stored in a climate-
controlled room.
7. Clean the spa interior.
8. Clean the filter cartridge(s).
9. Reinstall the DuraCover™ and lock in place.
NOTE: Direct sunlight on the spa surface can
cause severe damage or blemishing and can
result in the voiding of any surface warranties.
10. For added protection, cover the entire spa with
a Marquis Protective Spa Cover.