Advanced Settings; Virtual Server - D-Link DIR-655 User Manual

Section 3 - Configuration
This will allow you to open a single port. If you would like to open a range of ports, refer to the next page.
Name:
Enter a name for the rule or select an application from the drop-down menu.
Select an application and click << to populate the fields.
IP Address:
Enter the IP address of the computer on your local network that you want
to allow the incoming service to. If your computer is receiving an IP address
automatically from the router (DHCP), you computer will be listed in the
Computer Name drop-down menu. Select your computer and click <<.
Private Port/
Enter the port that you want to open. The private and public ports are
Public Port:
usually the same. The public port is the port seen from the Internet side, and
the private port is the port being used by the application on the computer
within your local network.
Protocol Type: Select TCP, UDP or Both.from the drop-down menu.
Schedule: The schedule of time when the Virtual Server Rule will be enabled. The
schedule may be set to Always, which will allow the particular service to
always be enabled. You can create your own times in the Tools > Schedules
section.
Inbound Filter: Select Allow.All (most common) or a created Inbound filter. You may create
your own inbound filters in the Advanced.>.Inbound.Filter page.
D-Link DIR-655 User Manual

Advanced Settings

Virtual Server

54