Windshield Washer Fluid; Adding Washer Fluid - Buick Enclave 2008 Owner's Manual

Windshield Washer Fluid

What to Use
When adding windshield washer fluid, be sure to read
the manufacturer's instructions before use. If operating
your vehicle in an area where the temperature may
fall below freezing, use a fluid that has sufficient
protection against freezing.

Adding Washer Fluid

When the windshield washer fluid reservoir is low, a
WASHER FLUID LOW ADD FLUID message will
be displayed on the Driver Information Center (DIC).
See DIC Warnings and Messages on page 3-56
for more information.
Open the cap with the
washer symbol on it.
Add washer fluid until the
tank is full. See Engine
Compartment Overview
on page 5-12 for reservoir
location.
Notice:
•
When using concentrated washer fluid, follow the
manufacturer's instructions for adding water.
•
Do not mix water with ready-to-use washer fluid.
Water can cause the solution to freeze and
damage your washer fluid tank and other parts of
the washer system. Also, water does not clean as
well as washer fluid.
•
Fill the washer fluid tank only three-quarters
full when it is very cold. This allows for fluid
expansion if freezing occurs, which could
damage the tank if it is completely full.
•
Do not use engine coolant (antifreeze) in your
windshield washer. It can damage the vehicle's
windshield washer system and paint.
5-35