Assembling The Main Axle And Drive Axle - Yamaha XT660R S Service Manual

http://manuals.magnamaniac.com
5 - 83
TRANSMISSION
2. Measure:
• drive axle runout
(with a centering device and dial gauge 1)
Out of specification → Replace the drive
axle.
Drive axle runout limit
0.08 mm (0.0031 in)
3. Check:
• transmission gears
Blue discoloration/pitting/wear → Replace
the defective gear(s).
• transmission gear dogs
Cracks/damage/rounded edges → Replace
the defective gear(s).
4. Check:
• transmission gear engagement
(each pinion gear to its respective wheel
gear)
Incorrect → Reassemble the transmission
axle assemblies.
5. Check:
• transmission gear movement
Rough movement → Replace the defective
part(s).
6. Check:
• circlips
Bends/damage/looseness → Replace.
ASSEMBLING THE MAIN AXLE AND DRIVE
AXLE
1. Install:
• toothed washer 1
• circlip 2
New
NOTE:
_
• Be sure the circlip shape-edged corner a is
positioned opposite side to the toothed
washer and gear.
• Install the circlip so that both ends b are
positioned in the center of each axle spline
c.
ENG