Removing The Cylinder Head - Yamaha XT660R S Service Manual

d
c
3
1
b
a
1
2
4
http://manuals.magnamaniac.com
CYLINDER HEAD
EAS00225

REMOVING THE CYLINDER HEAD

1. Align:
• "I" mark a on the A.C. magneto rotor
(with the stationary pointer b on the A.C.
magneto cover)
M MMM M MMM M M MMM
a. Turn the crankshaft counterclockwise.
b. When the piston is at top dead center (TDC)
on the compression stroke, align the "I"
mark c on the camshaft sprocket with the
stationary pointer d on the cylinder head.
L LLL L LLL L L LLL
2. Loosen:
• camshaft sprocket bolts 1
NOTE:
While holding the A.C. magneto rotor nut with
a wrench, remove the bolt.
3. Loosen:
• timing chain tensioner cap bolt
4. Remove:
• timing chain tensioner
(along with the gasket)
• camshaft sprocket
• timing chain
NOTE:
_
To prevent the timing chain from falling into the
crankcase, fasten it with a wire.
5. Remove:
• cylinder head
NOTE:
_
• Loosen the bolts in the proper sequence as
shown.
• Loosen each bolt 1/2 of a turn at a time. After
all of the bolts are fully loosened, remove
them.
5 - 10
ENG
M M MMM M M MMM M
L L LLL L L LLL L
M MMM M MMM
L LLL L LLL