1
2
1
c
a
b
http://manuals.magnamaniac.com
NOTE:
_
• To install the clutch cover, position the pull
rod so that the teeth face towards that rear of
the motorcycle.
• Tighten the clutch cover bolts in stages and
in a crisscross pattern.
8. Install:
• pull lever spring 1
• pull lever 2
• washer
• circlip
NOTE:
_
• Install the pull lever with the "UP" mark facing
up.
• Align the punch mark a on the pull lever with
a
the punch mark b on the clutch cover.
• Install the pull lever spring 1 as shown.
b
9. Install:
• clutch cable 1
10.Check:
• clutch cable length a
NOTE:
• Push the pull lever in direction b and check
the cable length a.
• Bend the tab c on the pull lever to secure
the clutch cable.
11.Adjust:
• clutch cable length
NOTE:
Move the pull lever a notch until the cable
length is within specification.
12.Adjust:
• clutch cable free play
5 - 49
CLUTCH
New
Out of specification → Adjust.
Clutch cable length
65.6 ~ 73.9 mm (2.58 ~ 2.91 in)
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" in chapter 3.
ENG