Dc Power Input - KVH Industries FleetBroadband FB250 Installation Manual

4.3 DC power input

4.3.1 Overview
The DC power input for the terminal is a 10.5 - 32 V DC; 14 A - 5.5 A input with
a remote on/off function. The input is protected against reverse polarity.
The power connector is a D-sub connector placed in the connector panel.
Important
For information on power recommendations and how to connect, see
Connecting power on page 53.
For TracPhone 19" Rack Terminal: To be able to use the power switch on the
front panel of the terminal you must connect the remote on/off pins in the DC
connector to the terminal block in the right side of the connector panel. For
further information, see 19" rack version only: Connecting to the power switch
on the front on page 61.
On the TracPhone 19" Rack Terminal, do not connect power to
the terminal block in the right side of the connector panel! The
terminal block is only for connection of the remote on/off
signal.
DC power input
Chapter 4: Hardware interfaces
67