Table of Contents
Advertisement
Installation Instructions
1. Locate the mounting template at the installation position and drill the ceiling
or wall if needed. (*The easy bracket can not be installed on the ceiling)
2. Place the easy bracket on pre-drilled position and attach using mounting
screws(4x30mm). Skip this step when an easy bracket is not installed.
3. Route the power cable to the connecting place.
Hook up the camera bracket with the easy bracket as illustrated below.
4. Attach the camera bracket using the assembly screws (4x14mm).
5. Set the camera's viewing angle.
6. Attach the sunshield to the camera unit and tighten the sunshield-bolt.
Assembly Screw
: 4x14mm
Torque Wrench
REAR VIEW
Plastic Anchor
: 6x30mm
Mounting Screw
: 4x30mm
4
9
1
2
3
Cable exit
Advertisement
Table of Contents
