A. Recommendations - Four winns 248 Vista Owner's Manual

T - 2 FUELING
Do not smoke, extinguish all open flames, STOP
all engines and other devices that could cause
sparks, including the bilge blower. Do not use
electrical switches or accessories. Shut OFF
all stoves that may produce a spark or flame.
Close all openings into the cabin area of the boat.

A. Recommendations

When fueling or having your boat fueled by an
attendant, be sure the waste pump-out or fresh
water fitting is not mistaken for the gas fill.
Although alcohol boosts the octane level of gasoline, it
also attacks the rubber fuel distribution lines and even
metal fuel system components. Alcohol will permeate
most fuel hoses and other components such as fuel
pump, gaskets and seals, and can also contribute to
fuel system contamination.
The hoses we use in our boats are alcohol-resistant as
are the materials used by the engine manufacturers. If
only fuel containing alcohol is available, or the presence
of alcohol is unknown, you must perform more frequent
inspections for leaks and abnormalities. Any sign of
leakage or deterioration requires your immediate atten-
tion. Refer to the engine manufacturer's recommenda-
tions on fuel type and octane ratings.
B. Preliminary Guidelines
1. Safely secure your boat to the dock.
2. Close all hatches, windows, doors and compartments
to prevent accumulation of fuel vapors.
3. Ensure that a fire extinguisher is readily available.
4. Do not store fuel in areas that are not adequately
ventilated.
5. Use only fuel lubricants recommended by the engine
manufacturer.
Vista™ Owner's Manual
™
C. Pumping Fuel
Follow engine manufacturer's recommendations
for types of fuel and oil. Use of improper products
can damage the engine and void the warranty.
1. Be sure to fuel in a well-lit area gasoline spills are
unnoticeable under poor lighting or in the dark.
2. Remove the gas fill cover.
3. Insert the fuel supply nozzle, keeping it in contact
with the fuel fill plate to guard against static produced
sparks.
4. Stand away from the fuel tank vent and gas fill during
fueling. Splashback may occur and can be an eye
irritant and/or a fire hazard.
5. Avoid spillage. Wipe up any excess fuel immedi-
ately.
6. After pumping approximately 10 gallons of fuel into
the fuel tank, inspect the engine and fuel tank area
for any signs of leakage. If no leaks or other prob-
lems are detected, resume fueling.
7. Allow space at the top of the tank for thermal expan-
sion.
8. If fuel cannot be pumped in at a reasonable rate,
check for fuel vent blockage or a kink in the line.
D. After Fueling
1. Replace the gas fill cover and wipe up any fuel spilled.
Discard rags used in a safe place ashore.
2. Open the engine compartment and all hatches, win-
dows, doors and other compartments that were
closed during fueling. Inspect these areas for the
odor of fuel vapors and visible fuel leakage.
Investigate and correct any sign of fuel leakage
or indication of vapors before starting engine.
Do not run blower or operate any electrical
switch until problem is corrected. Fire or explo-
sion may result.
Section T
Page 2