End Of Programme; Maintenance And Cleaning; Cleaning The Detergent Drawer; Draining Remaining Water And Cleaning The Pump Filter - Beko WMB 81241 L User Manual

Machine is in Rinse Hold mode

Spin symbol flashes and Pause symbol illuminates
when the machine is in Rinse Hold mode.
If you want to spin your laundry when the machine
is in this mode:
Adjust the spin speed and press Start / Pause /
Cancel button. Pause symbol disappears and Start
symbol appears. Programme resumes, discharges
the water and spins the laundry.
If you only want to drain the water without spinning:
Just press Start / Pause / Cancel button. Pause
symbol disappears. Start symbol appears.
Programme resumes and discharges the water
only.

End of programme

"End" appears on the display at the end of the
programme. Symbols of the programme steps
remain lit. Auxiliary function, spin speed and
temperature that were selected at the beginning of
the programme remain selected.

5 Maintenance and cleaning

Service life of the product extends and frequently
faced problems decrease if cleaned at regular
intervals.

Cleaning the detergent drawer

Clean the detergent drawer at regular intervals
(every 4-5 washing cycles) as shown below in order
to prevent accumulation of powder detergent in
time.
Press the dotted point on the siphon in the softener
compartment and pull towards you until the
compartment is removed from the machine.
C
If more than normal amount of water and
softener mixture starts to gather in the softener
compartment, the siphon must be cleaned.
Wash the detergent drawer and the siphon with
plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to
avoid touching of the residues in the drawer with
your skin when cleaning. Insert the drawer back
into its place after cleaning and make sure that it is
seated well.
If your detergent drawer is the one indicated in the
following figure:
C
Lift the rear part of the siphon to remove
it as illustrated. After performing the above
mentioned cleaning procedures, replace the
siphon back to its seating and push its front
section downwards to make sure that the
locking tab engages.

Cleaning the water intake filters

There is a filter at the end of each water intake valve
at the rear of the machine and also at the end of
each water intake hose where they are connected
to the tap. These filters prevent foreign substances
and dirt in the water to enter the washing machine.
Filters should be cleaned as they do get dirty.
Close the taps. Remove the nuts of the water intake
hoses to access the filters on the water intake
valves. Clean them with an appropriate brush. If the
filters are too dirty, take them out by means of pliers
and clean them. Take out the filters on the flat ends
of the water intake hoses together with the gaskets
and clean thoroughly under running water. Replace
the gaskets and filters carefully in their places and
tighten the hose nuts by hand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid
items such as buttons, coins and fabric fibers
clogging the pump impeller during discharge of
washing water. Thus, the water will be discharged
without any problem and the service life of the
pump will extend.
If the machine fails to drain water, the pump filter
is clogged. Filter must be cleaned whenever it
is clogged or in every 3 months. Water must be
drained off first to clean the pump filter.
In addition, prior to transporting the machine (eg.,
when moving to another house) and in case of
freezing of the water, water may have to be drained
completely.
A
Foreign substances left in the pump filter may
damage your machine or may cause noise
14
EN