SECURITY AND LOCKS [ADVANCED KEYLESS SYSTEM]
IMMOBILIZER SYSTEM CONSTRUCTION/OPERATION
• Keys contain a unique ID number that is previously programmed to the keyless control module and PCM. Due
to this, if immobilizer system component parts are replaced (such as key addition/clearing or replacement of
the keyless control module, instrument cluster or PCM), it is necessary to reset the system.
Key ID Number Verification Procedure
The start knob is pressed and the ignition switch is turned
to the ON position.
(4)
The PCM verifies that the received key ID number matches
the key ID number which has already been programmed.
Engine start is enabled.
(The security light illuminates approx. 3 s and goes off.)
AUXILIARY KEY
COIL ANTENNA
(TRANSPONDER)
(2)
09–14A–20
Result: OK
Result: OK
KEYLESS
CONTROL
MODULE
(1)
(2)
Result: NG
Result: NG
Engine start is disabled.
(The security light starts flashing/illuminating after an
error, such as verification failure or malfunction, is
detected, and then indicates the DTC for ten times
repeatedly.)
SECURITY LIGHT
INSTRUMENT
CLUSTER
(3)
E5U091467000N03
INSTRUMENT CLUSTER
PCM
(4)
E5U914AS1017