Operation - Superior BRT4036TEN Installation And Operation Instructions Manual

FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
a fire or explosion may result
causing property damage, per-
sonal injury or loss of life.
A. This appliance has a pilot that is
equipped with an ignition device which
automatically lights the pilot. Do not
light the pilot by hand.
B. BEFORE LIGHTING smell all around
the appliance area for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do
not use any phone in your building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
C. Use only your hand to push in or turn
the gas control knob. Never use tools.
If the knob will not push in or turn by
hand, don't try to repair it, call a quali-
fied service technician or gas supplier.
Force or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been under
water.
LIGHTING
INSTRUCTIONS
NOTICE: During initial operation
of new fireplace, burning logs
will give off a paper-burning
smell. Orange flame will also
be present. Open damper or
window to vent smell. This will
only last a few hours.
126737-01B

OPERATION

www.SuperiorFireplaces.US.com
1. STOP! Read the safety information, col-
umn 1.
2. Turn wall switch (if installed) to the OFF
position.
3. Turn off all electric power to appliance.
4. Place damper in full open position.
5. Fully open glass doors if installed.
6. Remove front refractory brick access
panel.
7. Turn equipment shutoff valve clockwise
to the OFF position (see Figure
37).
8. Wait five (5) minutes to clear out any gas.
Then smell for gas, including near the
floor. If you smell gas, STOP! Follow "B"
in the safety information, column 1. If you
don't smell gas, go to the next step.
9. Turn equipment shutoff valve counter-
clockwise
not force.
10. Replace front refractory brick access
panel.
11. Fully close glass doors if installed.
12. Turn on all electric power to appliance.
13. Turn Wall switch to the ON position.
14. Visually locate pilot. Ignitor should begin
to spark and main burner should ignite
once flame appears at pilot.
• If lighting appliance for the first time
each season, it may take several
attempts before supply gas can
reach pilot and main burner.
• If appliance will not stay lit after sev-
eral attempts, follow instructions in
To Turn Off Gas To Appliance, and
call your service technician or gas
supplier.
Equipment
Shutoff Valve
Figure 37 - Turning Equipment Shutoff
Valve to the OFF Position
to the ON position. Do
Adjustment
Screw
19