Operation - Superior BRT2032TMN Installation And Operation Instructions Manual

FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not follow these instructions
exactly, a fire or explosion may result causing property
damage, personal injury or loss of life.
A. This appliance has a pilot which must be lighted by hand. When
lighting the pilot, follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance area for gas.
Be sure to smell next to the floor because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not use any phone in your
building.
• Immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C. Use only your hand to push in or turn the gas control knob. Never
use tools. If the knob will not push in or turn by hand, don't try
to repair it, call a qualified service technician or gas supplier.
Force or attempted repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system and any
gas control which has been under water.
18

OPERATION

NOTICE: During initial operation of new fireplace,
burning logs will give off a paper-burning smell.
Orange flame will also be present. Open damper or
window to vent smell. This will only last a few hours.
1. STOP! Read the safety information in column 1.
2. Turn wall switch (if installed) to the OFF position.
3. Turn off all electric power to appliance.
4. Place damper in ful open position.
4. Fully open glass doors if installed.
5. Remove front refractory brick access panel.
6. Turn gas control knob clockwise
Figure 33).
7. Wait five (5) minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas, STOP! Follow "B" in the
safety information, column 1. If you don't smell gas, go to the next
step.
8. Turn control knob counterclockwise
9. Push knob in all the way and hold. Immediately light pilot manu-
ally. Continue to hold control knob in for about 1 minute after pilot
is lit. Release knob and it will pop back up. Pilot should remain lit.
If it goes out, repeat steps 5 through 9.
• If knob does not pop up when released, stop and immediately
call your service technician or gas supplier.
• If pilot will not stay lit after several tries, turn gas control knob
to OFF and call your service technician or gas supplier.
10. Turn gas control knob counterclockwise
be turned to ON only if control knob is popped out.
11. Replace front refractory brick access panel.
12. Fully close glass doors if installed.
13. Turn on all electric power to appliance.
Position
Indicator
Figure 33 - Control Knob in the PILOT Position
SuperiorFireplaces.us.com
LIGHTING
INSTRUCTIONS
Gas Control Pilot Adjustment
Knob Screw
ON
OFF
IN OUT
to the OFF position (see
to the PILOT position.
to ON. Knob can
126745-01E