Superior BRT4036TEN Installation And Operation Instructions Manual page 14

CAUTION: Compounds used
on threaded joints of gas piping
shall be resistant to the action
of Liquefied Petroleum (LP or
propane) and should be applied
lightly to ensure excess sealant
does not enter the gas line.
WARNING: All gas piping
and connections must be tested
for leaks after the installation is
completed.
After ensuring that gas valve
is on, apply a commercial leak
detection solution to all con-
nections and joints. If bubbles
appear, leaks can be detected
and corrected.
Do not use an open flame for leak
testing and do not operate any
appliance if a leak is detected.
Gas Shutoff
Valve
1/2" NPT
Incoming
Gas Line
Figure 19 - Connecting Flexible Gas Line to Millivolt Valve
Grate
Vermiculite
(Pan Material)
Figure 20 - Fill Entire Burner Pan with
Vermiculite
14
INSTALLATION
Continued
Flexible Gas Line
Do NOT Kink
Note:
1) Wire Connections
Not Shown for Clarity
2) * 1/8" NPT Plugged
Tapping
Burner Pan
www.SuperiorFireplaces.US.com
Complete your gas installation by connect-
ing incoming gas line with flexible gas line.
Secure tightly with wrench but DO NOT
OVERTIGHTEN.
EMBER AND PAN MATERIAL
PLACEMENT
1. Open bag(s) of vermiculite and fill entire
burner pan until burner tube is completely
covered (see Figure 20).
2. Smooth pan material just even with edges
of burner pan.
3. Remove ember material from bag and
flatten small amounts into quarter size
pieces and lay on top of surface of pan
material (see Figure 21).
4. Place just enough to cover entire surface
and leave about a 1/2" gap under lower
grate members to allow air to flow (see
Figure 22, page 15).
Red Surface Indicates For
Propane/LP Use Only
ON
OFF
IN OUT
Inlet Pressure Tap
Ember
Material
Grate
Figure 21 - Ember Material on Surface of
Pan Material (Vermiculite)
Pilot Adj
Outlet
Pressure Tap
Vermiculite (Pan Material)
Burner
Pan
126737-01B