Module Port Descriptions - Juniper 5000 SERIES User Manual

Appendix B Port Descriptions and LED Status
M P
ODULE ORT
The following table describes the ports on the 5000-M and 5000-M2 management
modules.
Port
Console
Modem
MGT
HA1
HA2
The following table describes the ports on the 5000-8G Secure Port Module (SPM).
Port
Network
Ports 1-8
The following table details the ports on the 5000-2G24FE module.
Port
Network Ports
1-2
Network Ports
3-26
46
D
ESCRIPTIONS
Description
Enables a serial connection, to establish
terminal sessions with the system. Used for
launching Command Line Interface (CLI)
sessions.
Enables a serial modem connection for
establishing dialup sessions.
Enables a connection for establishing out-of-
band management sessions from outside of the
network.
Enables connection with another device in a
redundancy cluster, where one device serves
as the master (primary) device, and the other
serves as the backup (secondary) device.
Enables connection with another device in a
redundancy cluster, where one device serves
as the master (primary) device, and the other
serves as the backup (secondary) device.
Description
Eight Gigabit ports with an aggregate throughput
of 8 Gbps.
Description
Two high-speed network ports for general
connection to the network.
24 network ports for general connection
to the network.
Type Speed/Protocol
RJ-45 9600 Bps/
RS-232
RJ-45 9600 Bps/
RS-232
RJ-45 10/100 Mbps/
Ethernet
mini-GBIC 1 Gbps/
Gigabit Ethernet
mini-GBIC 1 Gbps/
Gigabit Ethernet
Type Speed/Protocol
mini-GBIC 1 Gbps/
Gigabit Ethernet
Type Speed/Protocol
mini-GBIC 1 Gbps
Gigabit Ethernet
RJ-45 10/100 Mbps/
Ethernet
User's Guide