Configuring The Chassis Alarm - Juniper 5000 SERIES User Manual

For example, if you assigned the MGT interface an IP address of
10.100.2.183
http://10.100.2.183
The NetScreen WebUI software displays the login prompt.
3. Enter netscreen in both the Admin Name and Password fields, then click
Login. (Use lowercase letters only. The Admin Name and Password fields are
both case sensitive.)
The NetScreen WebUI application window appears.
C
ONFIGURING THE
The NetScreen-5000 Series device allows you to configure the chassis alarm, an audible
warning that sounds when a system failure or hazardous event occurs. To determine
which failures and events trigger the chassis alarm:
1. Configure the audible alarms by executing the following command:
set chassis audible-alarm string
where string can be any of the following keywords:
all
battery
fan-failed
power-failed
temperature
2. After configuring the alarm, it is advisable to view alarm environment
information by executing the following command:
get chassis
NetScreen-5000 Series
/16, enter the following:
C A
HASSIS LARM
Enables all chassis alarms.
Sets the chassis alarm to sound when a battery fails.
Sets the chassis alarm to sound when a fan fails.
Sets the chassis alarm to sound when a power supply fails.
Sets the chassis alarm to sound when the temperature goes outside of
the acceptable range.

Configuring the Chassis Alarm

31