Removing And Installing A Mini-Gbic Transceiver - Juniper 5000 SERIES User Manual

R
EMOVING AND
To remove a mini-GBIC transceiver from a module:
1. Push in the black ejector (located on the underside of the transceiver) until it
locks into place, disengaging the transceiver.
2. Grasp the transceiver at both sides then, firmly but gently, pull the transceiver
toward you to remove it from the module.
To install a mini-GBIC transceiver into a module:
1. Grasp the transceiver with the label facing up, then insert it into the transceiver
slot until seated.
2. Check to see if the black transceiver ejector extends fully out to the front of the
ejector slot, flush with the port portion of the transceiver.
NetScreen-5000 Series

Removing and Installing a Mini-GBIC Transceiver

I
NSTALLING A
M -GBIC T
INI RANSCEIVER
39