Consumer Safety Information; Safety Instructions; Filling The Water Reservoir - Bionaire BCM658X3-CN Instruction Leaflet

O P E R AT I N G - I N S T R U C T I O N S
22. DO NOT plug in the cord with wet hands: electric shock
could result.
23. DO NOT pour water in any openings other than the
water reservoir.
24. To prevent damage to surfaces, do not place humidifier
under overhanging surfaces.
25. NEVER operate unit without water in the reservoir.
26. Use both hands when carrying full reservoir of water.
PLEASE READ AND SAVE
THESE IMPORTANT

SAFETY INSTRUCTIONS

Consumer Safety Information

NOTE: This is an electrical appliance and requires attention
when in use.
NOTE: If moisture forms on the walls or windows of the
room, turn off the humidifier. The room already has plenty of
humidity and additional moisture may cause damage.
Cord and Plug Installation Safety Instructions
The length of cord used on this appliance was selected to
reduce the hazards of becoming tangled in, or tripping over
a longer cord. If a longer cord is necessary an approved
extension cord may be used. The electrical rating of the
extension cord must be equal to or greater than the rating of
the humidifier (refer to the rating information placed on the
humidifier). Care must be taken to arrange the extension
cord so that it will not drape over the countertop or tabletop
where it can be pulled on by children or accidentally tripped
over.
HOW COOL MIST WORKS
Your Bionaire Cool Mist humidifier draws dry air through the
®
rear air intake grill area. This air is then passed through a
moisture-laden wick filter, which retains the minerals and
deposits in the water. The resulting moist air is directed back
into the room from the top air grill.
NOTE: This humidification system provides a cool, invisible
moisture output. It is normal not to see the mist.
NOTE: A humidity level below 20% can be unhealthy and
uncomfortable. The recommended humidity level is between
40%-50%.
PRE-OPERATING INSTRUCTIONS
1. Be sure the humidifier is switched to OFF and the unit is
disconnected from the electrical outlet.
2. Select a location for your humidifier, on a flat level
surface, about 4 inches (10 cm) away from the wall. DO
NOT place the humidifier on a finished floor or near
furniture, which can be damaged by too much moisture
or water. Place on a moisture resistant surface.

FILLING THE WATER RESERVOIR

1. Remove the reservoir from the housing of the humidifier
by grabbing the handle of the reservoir and pulling
forward. Lift the reservoir out of the housing and bring
to the faucet. Turn the reservoir upside down and twist
off the reservoir cap by turning counter clockwise. Fill
reservoir with cool, fresh tap water. DO NOT fill with
warm water as this may cause leaking. Replace the cap
on reservoir FIRMLY.
2. When full, carry the reservoir to the humidifier and
place it into the housing. There is a locating tab located
on the reservoir base for easy guidance. The reservoir
holds 1.3 gallons of water. The reservoir will immediately
begin to empty into the base.
3. Plug the power cord into a 120V AC electrical outlet.