Bionaire BCM646 Instruction Leaflet

BCM646_08EM1.qxd:BCM646_08EM1.qxd 5/29/08 8:58 AM Page 1
CLEANING AND MAINTENANCE INSTRUCTIONS TO DISINFECT RESERVOIR
Humidifiers provide comfort by adding moisture to dry, 1. Fill humidifier reservoir 1/2 full with water and 1/2
heated indoor air. To benefit most from the humidifier and tablespoon of chlorine bleach.
avoid product misuse, follow all instructions carefully.
2. Let the solution stand for 20 minutes, swishing every
Please note that this is an electrical appliance and
few minutes. Wet all surfaces.
requires attention when in use.
3. Carefully empty the reservoir after 20 minutes, and
In addition, if you do not follow the recommended care
rinse with warm water until you can not detect any
and maintenance guidelines, micro-organisms may be
bleach smell. Dry with a clean cloth or paper towel.
able to grow in the water within the water tank. You must
4. Place filter back into reservoir and refill the water
routinely follow the cleaning procedures that follow in
reservoir as directed in Operating Instructions, and
order to ensure proper, efficient operation of your
turn the unit on.
humidifier. Proper maintenance and cleaning is essential
to the continued performance of your unit and the
STORAGE INSTRUCTIONS
avoidance of algae or bacteria build-up.
When not using your humidifier for an extended period
DAILY MAINTENANCE of time:
1. Be sure the unit is OFF and is disconnected from the 1. Dispose of the filters. DO NOT leave in unit.
electrical outlet.
2. Clean, rinse and thoroughly dry the humidifier as
2. Remove the housing and the tank from the humidifier
directed in weekly maintenance. DO NOT leave any
and place in sink or tub.
water in the unit when storing. Leaving water in the
unit may render the unit inoperable for the following
3. Carry the base of the unit to the sink, remove the
season.
wick, place in sink, drain any remaining water and
rinse thoroughly to remove any sediment or dirt. Wipe
3. Place the humidifier in the original carton and store in
clean, and dry with a clean cloth or paper towel.
a cool, dry place.
4. Drain the water from the tank into the sink and rinse 4. Order your replacement filter for next year's use.
tank thoroughly. Wipe clean, and dry with a clean
cloth or paper towel.
5. Put filter back in, replace the housing, then refill tank
with cool tap water as instructed earlier in the Filling
Instructions. Do not overfill.
6. Follow Operating Instructions.
WEEKLY MAINTENANCE
To Remove Scale:
1. Repeat steps 1-4 above.
2. Clean the base by partially filling the base with one 8-
oz cup of undiluted white vinegar, or by using Clean
Away TM (Model DMS216) by the manufacturer. Leave
this solution in the base for 20 minutes, while cleaning
all interior surfaces with a soft brush. Remove base
scale by wiping the base with a cloth dampened with
undiluted white vinegar.
3. Rinse with clean warm water to remove the cleaning
solution before disinfecting the tank.
1 YEAR LIMITED WARRANTY
TROUBLESHOOTING
Trouble
Probable Cause Solution
☛ Not plugged in ✔ Plug in Unit
• Unit does not turn on
• Mist output minimal ☛ Filter has not absorbed ✔ Wait 30 minutes for filter to
to none water absorb water
• Filter turns brown ☛ The filter has absorbed ✔ Replace your filter (BWF100)
minerals by calling 1-800-253-2764 or
visiting: www.bionaire.com
☛ Takes 60 minutes to register
• FilterCheck ® is ✔ Allow the humidifier to run
not working
continuously for 60 minutes
for the FilterCheck ® Indicator
to reflect the filter condition
✔ Continue to operate humidifier
☛ Humidity at the humidifier is
• Humidifier continuously
to raise the room humidity
displays 21% at or below 21%
✔ Stop operating the humidifier
☛ Humidity at the humidifier is
• Humidifier continuously
if the humidity level is too high
displays 90% at or above 90%
FREQUENTLY ASKED QUESTIONS
Answer
Question
☛ The estimated run time for this humidifier is based on
• What are the variables that
affect run time? average room conditions. The actual run time of your
humidifier is dependent on numerous variables such as:
1. Air exchange in the room where the humidifier is
placed.
2. Room construction of the room where the humidifier
is placed.
3. Temperature of the room where the humidifier is
placed.
4. Humidity levels in the room where the humidifier is
placed.
5. Movement of occupants and the opening and clos- What are the limits on JCS's Liability?
ing of doors in the room where the humidifier is
placed.
6. Home furnishings in the room where the humidifier is
placed.
☛ See Daily Maintenance instructions. Regular cleaning is
• How do I remove film on
water tank? recommended.
☛ Run your unit on the lowest setting.
• How can I extend the run
☛ If your unit has electronics, set it to your desired
time?
humidity level. The unit will turn on and off, which will
extend the run time.
☛ Fill the tank all the way full, place it on the base, let the
water empty into the base until it stops bubbling, then
refill the tank full again. This ensures maximum water
capacity and will extend run time.
How to Obtain Warranty Service
PLEASE DO NOT RETURN THIS PRODUCT TO ANY
OF THESE ADDRESSES OR TO THE PLACE OF
PURCHASE.
If after having read this leaflet, you have any
BCM64608EM1 Printed in China
digital COOL MOISTURE
humidifier
BCM646
MODEL:
FILTER#: BWF100/HWF100 (2)
Filter Type: Wick
Read instructions before operating.
Retain for future reference.
Instruction Leaflet
☎
INFO-LINE
questions or comments on your humidifier,
call 1-800-253-2764 in North America.
127053/9100030004879