Rear WheelISuspension
Brake dust may contain asbestos fibers.
Never use an air hose or drv brush to clean brake assemblies. Use an OSHA-auuroved vacuum cleaner or alternate method
. .
approved by OSHA, designed to minimize the hazard caused by airborne asbestos fibers.
.
.
.
Inhaled asbestos fiber have been found to cause respiratory disease and cancer.
Keep grease off of brake drum and shoes.
CAUTION
A contaminated brake drum or shoe reduces stopping power. Discard contaminated shoes and clean a
contaminated disc w i t h a high quality brake degreasing agent.
NOTE
For driven sprocket removal, loosen the sprocket nuts with the driven flange installed into the wheel hub.
Replace wheel bearings as a set.
.
For wheel bearing replacement, refer to section 1 of the Common Service Manual.
Requisite Service
.
Rear wheel removallinstallation (page 11-21
1
Procedure
1
Q'W
I
Remarks
I
Disassembly Order
(8)
O-ring
(9) Rear wheel damper
(10) Left wheel bearing (6303 UU)
(1 1 ) Distance collar
(12) Right wheel bearing (6303 UU)
/
(1 3)
/
Rear wheelltire
Drive in the right side
ing.
1
bearing first, then the left side bear-
-
A ssembly is in the reverse order of disassembly
At assembly, apply grease to the dust seal lips.