Dtc P0337 - Mazda 6 Workshop Manual

Diagnostic procedure
STEP
1 VERIFY FREEZE FRAME DATA HAS BEEN
RECORDED
• Has FREEZE FRAME DATA been recorded?
2 VERIFY RELATED REPAIR INFORMATION
AVAILABILITY
• Verify related Service Information availability.
• Is any related repair information available?
3 VERIFY CURRENT SIGNAL STATUS: IS
CONCERN INTERMITTENT OR CONSTANT?
• Connect the WDS or equivalent to the DLC-2.
• Clear the DTC from the PCM memory using
the WDS or equivalent.
• Start the engine.
• Is the same DTC present?
4 INSPECT CKP SENSOR PULSAR
• Inspect the CKP sensor pulsar for damage
and/or cracks.
• Is there any malfunction?
5 INSPECT CKP SENSOR CONNECTOR FOR
POOR CONNECTION
• Turn the engine switch off.
• Inspect for poor connection (such as damaged/
pulled-out terminals, corrosion).
• Is there any malfunction?
6 INSPECT CKP SENSOR
• Inspect the CKP sensor.
• Is there any malfunction?
7 INSPECT PCM CONNECTOR FOR POOR
CONNECTION
• Turn the engine switch off.
• Inspect for poor connection (such as damaged/
pulled-out terminals, corrosion).
• Is there any malfunction?
8 VERIFY TROUBLESHOOTING OF DTC P0336
COMPLETED
• Make sure to reconnect all disconnected
connectors.
• Clear the DTC from the PCM memory using
the WDS or equivalent.
• Start the engine.
• Is the same DTC present?
9 VERIFY AFTER REPAIR PROCEDURE
• Perform the Repair Verification Drive Mode.
(See F2–39 OBD DRIVE
• Are any DTCs present?
End Of Sie

DTC P0337

DTC P0337 CKP sensor circuit low input
• The PCM monitors the input signal from the CKP sensor and the CMP sensor while the engine is running.
If the input signal from the CKP sensor is not input while the PCM detects 28 pulses from the CMP sensor,
the PCM determines that there is a malfunction in the CKP sensor circuit.
DETECTION
Diagnostic support note
CONDITION
• The MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
• FREEZE FRAME DATA is available.
• The DTC is stored in the PCM memory.
ON-BOARD DIAGNOSTIC
INSPECTION
MODE.)
Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order,
then go to the next step.
Yes Perform repair or diagnosis according to the available
Service Information.
• If the vehicle is not repaired, go to the next step.
No Go to the next step.
Yes Go to the next step.
No Intermittent concern exists.
Perform the "INTERMITTENT CONCERNS
TROUBLESHOOTING".
Yes Replace the CKP sensor pulsar, then go to Step 8.
No Go to the next step.
Yes Repair or replace the suspected terminal, go to Step 8.
No Go to the next step.
Yes Replace the CKP sensor, go to Step 8.
No Go to the next step.
Yes Repair or replace the suspected terminal, go to the next
step.
No Go to the next step.
Yes Replace the PCM, go to the next step.
No Go to the next step.
Yes Go to the applicable DTC inspection.
(See F2–40 DTC TABLE.)
No Troubleshooting completed.
ACTION
B6E407000300103
F2–117
F2