The Handset Layout - VTech 20-2432 User Manual

Enter Base ID Code
1. After charging the Handset, remove it from its
Charge Cradle; the screen will display:
alternating with this screen:
2. If, after charging the Handset, you see:
3. Press NEW. You will now see the ENTER BASE
ID screen as described in step 1.
4. Find the BASE ID Code by doing the following: (the Base must be in idle (OFF)
mode)
A. At the Base, press MENU
B. Scroll down to DISPLAY BASE-ID
C. Press OK. The Base screen will display the 15-digit ID Code for approximately
60 seconds. Afterwards, it will return to the idle screen.
5. Enter the 15-digit Base ID Code into the Handset ; then press OK.
6. Wait approximately 15 to 60 seconds. You
will hear confirmation beeps from the Base
and Handset. The newly registered Handset
will now assign itself the lowest handset
number not previously assigned to a different
system Handset (1 through 8).
7. If the Handset displays REJECTED BY BASE or continues to display
SEARCHING FOR BASE for well beyond 60 seconds, try the registration process
again by repeating the above steps.
Congratulations! You can now enjoy the benefits of your 2-Line Multi-Handset
system.
Registration
OK
MENU
6
1. Antenna
2. Message Waiting Indicator
3. Earpiece
4. Headset Jack (2.5mm)
5. Scroll Keys
6. Line 1 (Flash)
7. Dialing Keys (0-9,*,#)
8. Handsfree Speakerphone
9. LCD Display

The Handset Layout

11
12
14
15
16
10. Select/OK
11. Off (Clear)
12. Line 2 (Flash)
13. Battery Compartment (back
of handset)
14. Billed Services Key
15. Intercom/Transfer Key
16. Microphone
7