VTech 20-2432 User Manual page 50

Getting Started Getting Started Getting Started
Getting Started Getting Started
Registration And Operation Of The 20-2422 Accessory
Handset
The accessory Handset consists of the following:
1
3
5
Setup
Setup Of The 20-2422
Accessory Handset
1.
Plug the AC power adapter into an
electrical outlet.
2.
Remove the Handset battery cover
by pressing on the indent and sliding
downward.
3.
Place the new battery pack in the
Handset, with the metal contacts
aligned with the charge contacts in
the battery compartment.
4.
Replace the battery cover by sliding
it upward.
5.
Place the Handset in the Charge
Cradle, and allow it to charge for 12
hours. After the initial charge, a
maintenance charge of 8 hours
should be sufficient.
4
Installation of Battery Pack in Handset
Your 2-Line 20-2432 system can operate up to 8 Handsets.
The original Handset that is shipped with your 2-Line system will be automatically
registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension
numbers in the following order: HANDSET 2, HANDSET 3, HANDSET 4, and so forth.
Whenever a Handset battery pack is installed, the Handset will automatically begin
SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER
BASE ID to register the new Handset.
BEFORE USING YOUR HANDSET(S), CAREFULLY PEEL OFF THE PROTECTIVE
FILM, COVERING THE DISPLAY.
5