Disconnect I C Cables; Figure 7. Disconnecting I - Intel SSR316MJ2 Installation Manual

Cable kit

Hide thumbs Also See for SSR316MJ2:

Table of Contents

SATA Cables Installation Procedures

Disconnect I

NOTE

The I

C cables are labeled at each end, on the cable connector. In the

instructions and the figure below, it is assumed that letter "A" corresponds to

your cable labeled JP4 and SL3_J13. Your connections may be different. It is

important that you write down the connections as they exist in your chassis,

so you may later correctly reconnect them.

In these steps, you do not need to disconnect the I

Bus Adapter cards. If you choose to disconnect the cables from the cards,

make sure you also write down these cable connections.

1. Write down the I

connect these cables to the same headers.

2. Disconnect the I

See letter "A" in the circled area of Figure 7.

3. Disconnect the I

circled area of Figure 7.

Intel

Storage System SSR316MJ2 Cable Kit

C Cables

C cable connector positions on the backplane board. You will later need to re-

C cable that is labeled JP4 from the backplane board at the front of the chassis.

C cable that is labeled JP6 from the backplane board. See letter "B" in the

C cables from the Host

C Cables

TP01804

Table of Contents

Fmjcables2