To Insert Bobbin Case Into The Machine; To Insert Needle - New Home 535 Manual Instruction

TO INSERT BOBBIN CASE INTO THE MACHINE

Raise the needle bar and take-up lever both to their highest point.
Open the slide plate.
Hold the bobbin case by the latch and place it on the centre post with
the bobbin case finger in the notch at the top of the shuttle.
Release the latch and press the bobbin case into the shuttle until the
latch catches on the centre post with a click.
Permit the thread to hang down freely a few inches.

TO INSERT NEEDLE

Insert the needle as high as it will go until it touches the pin which
is visible in the slot above the needle clamp and tighten the needle
clamp screw firmly.
Raise the needle bar (A) to its highest
point by turning the balance wheel
with your right hand.
Loosen the needle clamp screw (8)
at the end of the needle bar, and
insert the needle (C), with the flat side
to the right, into the slot of the needle
bar.