Taillamps, Turn Signal, And Stoplamps; License Plate Lamp - Chevrolet 2011 Camaro Owner's Manual

Taillamps, Turn Signal,
and Stoplamps
To replace a taillamp, turn signal,
or stoplamp bulb:
1. Open the trunk. See Trunk on
page 2 9.
2. Remove the close out panel
retainers to gain access to the
bulb socket connectors.
3. Turn the bulb socket
counterclockwise to remove it.
4. Pull the old bulb straight out of
the bulb socket.
5. Push the new bulb straight into
the bulb socket until it clicks.
6. Turn the bulb socket clockwise
to reinstall.

License Plate Lamp

To replace one of these bulbs:
1. Unclip the license plate lamp
from the fascia opening.
2. Pull the license plate lamp down
through the fascia opening.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
3. Turn the bulb socket
counterclockwise and pull
the bulb straight out of the
lamp socket.
4. Install the new bulb.
5. Push the bulb straight into the
socket and turn clockwise to
reinstall.
6. Reinstall the license plate lamp
by lifting it through the fascia
opening until the clip is in place.
10-41