Advertisement
1999 Cougar Workshop Manual
13. NOTE: Turn the crankshaft two revolutions in the normal direction of rotation.
Check the valve timing by inserting the special tool. Correct it, if necessary.
Screw in special tool 303-574 and make sure that the crankshaft is touching it.
Insert special tool 303-465 into the camshafts; if necessary loosen the timing pulleys and correct the camshaft alignment.
Detach the special tools.
14. NOTE: Use a new blanking plug.
Install the blanking plug on the exhaust camshaft pulley.
15. NOTE: Valve cover tightening sequence: From the inside outwards, working diagonally.
Install the valve cover and spark plugs.
1. Install the spark plugs.
2. Install the valve cover.
16. Install the HT wires and crankcase ventilation hose.
1. Connect the crankcase ventilation hose.
2. Connect the HT wires to the spark plugs.
17. Install the appearance cover.
1. Install the eight bolts.
2. Connect the solenoid valve electrical connector and press in the rubber seal.
18. Clip the throttle cable and the speed control cable to the appearance cover.
19. NOTE: Set the upper part of the engine front cover together with the center part in place.
Install the center part of the engine front cover.
http://www.fordtechservice.dealerconnection.com/pubs/content/~WSXU/~MUS~LEN/21/...
Page 7 of 10
12/1/2009
Advertisement
