Change The Retransfer Ribbon - Rimage Professional 3400 User Manual

Rimage Professional 3400 and 5400N User Guide
h. Set the print ribbon carrier upright.
Tip: When the print ribbon carrier is upright, the
supply roll is at the top of the carrier.
i. Rotate the take-up roll clockwise to tighten the ribbon.
Make sure that the ribbon is aligned and lies flat on the
carrier.
Tip: You may need to lift the ribbon up from the
tacky roller to straighten it.
 Notes:
•
Do not rotate the ribbon past the black
cleaning bars at the front of the ribbon.
•
If you installed a black (monochrome) ribbon,
advance the ribbon so the ink portion of the ribbon is
advanced to the take-up roll.
3. Reassemble the printer.
a. Slide the print ribbon carrier into the printer.
b. Turn the center latch clockwise to lock it.
c. Close the printer cover.
 Note: Ribbon color can vary from lot to lot. After you load the new ribbon, you may need to adjust the density
settings in the printer driver. Refer to the
more information.
The printer is ready for use.

Change the Retransfer Ribbon

Before you change or first install the Everest retransfer ribbon, allow time for the new ribbon to become acclimated to the
environment. Allow more time for greater temperature and humidity differences.
-
Important!
• Rimage supports only the use of Rimage brand ribbons in our printers. Printer issues that occur as a result of
using ribbons by manufacturers other than Rimage are not included under your Rimage warranty or maintenance
agreement.
• For optimum results, make sure that Everest ribbons are stored at a temperature between 41° and 95°F (5° to 35°C)
and humidity level between 45% and 85%.
• Avoid moisture and direct sunlight.
• Do not reuse ribbons.
• Make sure you only use ribbons designed for your model of Everest 400 printer.
• The ribbon carriers cannot be removed from the printer unless the system is powered on.
30
Supply Roll
Adjust the Print Alignment and Color Density section on page 25 for
2001431_B