Acura Integra Sedan 2000 Owner's Manual page 178

Main Menu Main Menu Table of Contents
RESERVE TANK
HOLDER
5. Remove the reserve tank from its
holder by pulling it straight up.
Drain the coolant, then put the
tank back in its holder.
6. When the coolant stops draining,
tighten the drain plug at the
bottom of the radiator. Put a new
washer on the drain bolt, then
reinstall the drain bolt in the
engine block. Tighten it securely.
Tightening torque:
58 Ibf . ft (78 N . m , 8.0 kgf . m)
7. Mix the recommended antifreeze
with an equal amount of purified
RESERVE
or distilled water in a clean
TANK CAP
container. The cooling system
capacity is:
With 5-speed manual transmission:
(LS, GS)
1.16 US gal (4.4 l ,0.97 Imp gal)
(GS-R)
1.24 US gal (4.7 l ,1.03 Imp gal)
With automatic transmission:
1.24 US gal (4.7 l ,1.03 Imp gal)
Cooling System
FILLER NECK
Fill up to here
8. Pour coolant into the radiator up
to the base of the filler neck.
9. Start the engine and let it run for
about 30 seconds. Then turn off
the engine.
Maintenance
CONTINUED