Ford B-Max Owner's Manual page 182

Note: When you drive to another part of the
country, stations that broadcast on
alternative frequencies, and are stored on
preset buttons, may be updated with the
correct frequency and station name for that
area.
Autostore Control
Note: This will store up to a maximum of
the 10 strongest signals available, either
from the AM or the FM waveband, and
overwrite the previously stored stations. You
can also store stations manually in the same
way as other wavebands.
• Press the MENU button, select audio
mode then press and hold the RADIO
button.
• When the search is complete, sound is
restored and the strongest signals are
stored on the autostore presets.
Traffic Information Control
Many stations that broadcast on the FM
waveband have a TP code to signify that
they carry traffic program information.
Turning Traffic Announcements On and
Off
Before you can receive traffic
announcements, you must press either the
TA or TRAFFIC button. A TA display will
appear to show the feature is switched on.
If you are already tuned to a station that
broadcasts traffic information, TP will also
be displayed. Otherwise the unit will search
for a traffic program.
When traffic information is broadcast, it
will automatically interrupt normal radio
or CD playback and Traffic
announcement will appear in the display.
If a non-traffic station is selected or
recalled using a preset button, the audio
unit will remain on that station unless TA
or TRAFFIC is turned off, then on again.
Audio System
Note: If traffic announcement is on and you
select a preset or manual tune to a non
traffic announcement station no traffic
announcement will be heard.
Note: When you are listening to a non
traffic announcement station and turn
traffic announcement off and on again a TP
seek will occur.
Traffic Announcement Volume
Traffic announcements interrupt normal
broadcasts at a preset minimum level that
is usually louder than normal listening
volumes.
To adjust the preset volume:
• Use the volume control to make the
necessary adjustment during an
incoming traffic announcement
broadcast. The display will show the
level selected.
Ending Traffic Announcements
The audio unit will return to normal
operation at the end of each traffic
announcement. To end the announcement
prematurely, press TA or TRAFFIC during
the announcement.
Note: If you press TA or TRAFFIC at any
other time it will switch all announcements
off.
Automatic Volume Control
When available, automatic volume control
adjusts the volume level to compensate
for engine noise and road speed noise.
1. Press the MENU button and select
AUDIO or AUDIO SETTINGS.
2. Select AVC LEVEL or ADAPTIVE
VOL.
3. Use the left or right arrow button to
adjust the setting.
4. Press the OK button to confirm your
selection.
180