34
1. Press OK to select the highlighted page set.
2. Press PAGE. The currently selected page set is represented on the soft keys.
3. Press the corresponding soft key to display a full window radar application.
4. The scanner warm-up countdown commences. This will take approximately 70 sec-
onds.
Note:
If your scanner is incompatible, a message is displayed. If this is the case, you will be
unable to proceed further with testing and aligning the radar. Refer to Important Informa-
tion - Radar Scanners at the front of this handbook.
Radar transmission check
With a radar application active, check the transmission to the scanner as follows:
1. Press the RANGE button and ensure that the radar range adjusts accordingly.
2. Check that all the following information is displayed:
• In the status bar - the range, orientation, motion mode and range ring spacing
• In the data bar - a turning radar status icon and vessel position data.
Range
Data bar
Status bar
3nm
Ship's
heading
marker
Boat's
position
Range
ring
VRM/EBL...
Radar alignment checks
You should check the bearing and display timing alignment to ensure that an accurate
picture is shown.
www.busse-yachtshop.de | info@busse-yachtshop.de
Orientation
Motion mode
Head-Up
Relative Motion
TARGET
TRACKING...
E-Series Installation Manual
Range ring
spacing
Rings ½nm
TARGETS
PRESENTATION...
GAIN...
DISPLAY...
Radar status
icon