Chapter 3: Installation; How Can The Display Unit Be Mounted; Mounting The Display On The Trunnion Bracket - Raymarine E-Series Installation Manual

Chapter 3: Installation

Chapter 3: Installation
CAUTION:
Please ensure that you have read Chapter 1: Preparation for installation
before proceeding.
CAUTION: Radar Scanners, Cables & Installation
Information on radar scanners, cables and their installation contained in
this handbook supersedes that contained in the Pathfinder Radar
Scanner Handbook, Document No. 81154_6, dated 11th March 2002.
Introduction
This chapter provides instructions for installing your E-Series Display. You may find that
your system does not use all the protocols or contain all of the instrumentation that is
described.

3.1 How can the display unit be mounted?

CAUTION: Installation
Make sure there are no hidden electrical wires or other items
behind the selected location before proceeding.
Make sure there is sufficient rear access for mounting AND
cabling.
The display unit is waterproof to CFR 46 and can be installed either above or below
deck using either the trunnion bracket or by flush mounting it in a suitable position.

Mounting the Display on the trunnion bracket

The display unit can be fitted on a dash, chart table, bulkhead or deckhead, using the
trunnion bracket:
You should fit the trunnion bracket as follows:
1. Mark the location of the trunnion bracket screw holes on the chosen mounting sur-
face.
2. Drill pilot holes for the screws using a suitable drill, taking care that there are no
cables or anything that may be damaged behind the surface.
3. Use the 5 bolts supplied (together with the washers and nuts) to securely attach the
bracket.
4. Before attaching the display unit to the bracket:
www.busse-yachtshop.de | info@busse-yachtshop.de
17