Encoding Replacement Rf Remote Controls; Activating The Encoding Function - BMW R 1200 CL Service Manual

R 1200 CL
Alarm System Programming Information

Encoding Replacement RF Remote Controls

Note:To encode RF Remote Controls
you will need the 5 digit "personal pin
code" for the alarm system.The code is
entered into the system by synchroniz-
ing the switching of the ignition key
when the appropriate LED flash corre-
sponds with each digit of the code.
A maximum of four RF remote controls
can be encoded on the system.

Activating the encoding function

Signal the five digit code to the system by switching the ignition key ON when
the total number of flashes occur for each number in the code.
1. Use a jumper to connect the pro-
gramming plug
ground.
2.Turn the ignition switch to ON,
after a brief pause switch to OFF .
3. Wait for the first digit code to
flash ON and then OFF . Once
OFF , switch the key back ON.
4. Pause for approximately 5 sec-
onds and switch ignition off.
Repeat this process for each of
the remaining digits in the code.
5. On completion of the last digit,
three beeps will be heard indi-
cating encoding
active.
NOTE: If the beeps are not heard,
you must repeat steps 2 - 5 ensur-
ing the key is switched ON after the
last flash of the coded number
switches OFF .
124
to battery
function is
Personal Pin Code Card
Example: Code input for 11559
R 1200 CL Introduction