Left Handlebar Controls; Switch Layout - BMW R 1200 RT-P 2015 Supplementary Instructions Manual

Left Handlebar Controls:

Switch Layout:

The left handlebar switch contains the standard operating controls for the police
motor. The horn switch also operates the siren air horn when the ignition is turned
"ON". A combination authority switch contains four rocker switches. These rocker
switches control your PTT & PTPA, PTT2, Optional LED Driving Lights, Alley Lights
and Take-Down Lights.
Push-to-Talk (F1):
The push-to-talk switch provides a +12v signal to the helmet headset interface plug,
which can be utilized by helmet headset interface units to trigger the push-to-talk
function in PVP and Setcom units. Alternatively, this switch can be programmed to
latch-on and then off with the next press (via ISTA).
Push-to-PA (F2):
The push-to-public address switch provides a +12v signal to the helmet headset
interface plug, which can be utilized by the helmet headset interface units to trigger
the push-to-public address function in PVP and Setcom units. Alternatively, this
switch can be programmed to latch-on and then off with the next press (via ISTA-P).
Note: The new generation handlebar switches utilized on the K52 models
incorporate LIN-bus control units, meaning that there are no conventional analog
signals created by the switches as in the past. Consequently, functions cannot be
swapped between buttons.
Map Light:
Connections for the BMW map light option are pre-wired on the right handlebar
switch cable bundle. The map light circuit is powered by the GMSF, providing power
for 30 minutes after ignition is turned "off".
Map Light + GE
1
2
Ground - BR
Radio Speaker Connection:
Two stereo radio speakers are standard equipment on the R 1200 RT-P. A
connection point to these 4Ω speakers is provided. Typical connections are for
police radio and radar Doppler audio.
1 LH Fairing Speaker + GE RT
2 LH Fairing Speaker - GE BR
4 RH Fairing Speaker + BL GE
Fairing Speaker Cut-Out BL VI
(BC Pin 7 – 2A,15 minutes after ign. off)
5 RH Fairing Speaker - BL BR
3 Auxiliary Wires BR GE
6 Auxiliary Wires SW GE
(Exit X1717 near FT fairing pocket)
The RH speaker can be turned-off via the RH handlebar switch to enable the rider to
temporarily mute the speaker when circumstances dictate.
Mating plug w/sockets is available under BMW PN 71 60 2 407 781
Accessory I, II, III Connections:
Three accessory connections located inside the radio box provide 12v and ground
connections for the installation of video system, thermal printers, flashlight chargers,
etc. Power is automatically controlled by the GMSF to each output and will
automatically terminate power after ignition-off as follows:
ACC I = 30 seconds
Auxiliary I (GMSF Pin 33 – 2A, 30 seconds after ign. off) GN RT
1
2 Ground BR
ACC II = 25 minutes ACC III = 30 minutes
Auxiliary II (GMSF Pin 35 – 2A, 25 minutes after ign. off) GN WS
1
2 Ground BR
Auxiliary II (GMSF Pin 36 – 2A, 30 minutes after ign. off) GN BL
1
2 Ground BR
Mating plug w/sockets (3) are available under BMW PN 71 60 2 407 783
Fairing Speaker Relay
Normally Closed
4 5 2 1 3