Table of Contents
Advertisement
Possible problems
Error messages in the
display
Your fax machine indicates operating
errors or does not carry out a function in
accordance with your requirements.
Before you contact customer service,
consider a moment and identify the error
message in the following list. You will
probably then be able to remedy the fault
yourself.
Display
BROKEN REGISTRATION
PRESS [STOP]
CONFIRM DIAL LIST
POWER FAILURE
TX COVER OPEN
RX COVER OPEN
MEMORY FULL
DOCUMENT JAM
UPPER PAPER EMPTY
MIDDLE PAPER EMPTY
LOWER PAPER EMPTY
PAPER EMPTY
TONER LOW
TONER EMPTY
DRUM LIFE WARNING
110
GB
Possible problems
General procedure to be followed for
error messages in the display
1. Analyse error message.
2. Rectify cause of error.
3. Press STOP key to cancel error message in
display.
4. If necessary, switch off fax machine for 10
seconds and press STOP key again.
Cause
Alphabet memory and internal settings have
been lost due to a lengthy power failure
Contents of the image memory have been lost
following a power failure.
The cover on which the keypad is located has
not snapped into position.
The upper part of your fax machine housing has
not snapped into position.
The transmission / reception memory is full.
Documents have jammed in the document
feeder.
(Only in conjunction with additional paper cas-
settes)
No more paper in the upper cassette.
(Only in conjunction with additional paper cas-
settes)
No more paper in the middle cassette.
(Only in conjunction with additional paper cas-
settes)
No more paper in the bottom cassette.
The recording paper is empty
The toner is almost out. Only enough toner for
approx. 100 more copies.
There is not enough toner for printing.
The printer unit is almost spent. About 100
sheets can be printed after this is displayed.
All error messages are re-
tained in the display until they
are acknowledged with the
STOP key. If this error message does
not disappear, the cause of the error
has still not been rectified.
How to correct
Press the STOP key. If the error message
does not disappear, activate the installa-
tion procedure
(see page
11) and confirm
all settings.
The mains error report
(see page
printed out in order to provide you with a
list of lost criteria.
Allow this cover to snap carefully into
position.
Close the housing cover carefully.
Send your document(s) with a lower
resolution, or send them using the direct
mode
(see page
36).
If this error persists, please contact your
dealer for a memory expansion.
Follow the instructions on
page 116
rectify the document jam.
Load new recording paper
(see page
Load new recording paper
(see page
Load new recording paper
(see page
Load new recording paper
(see page
Install a new cartridge
(see page
Install a new cartridge
(see page
Please contact your TOSHIBA dealer for
ordering a new printer unit.
TOSHIBA
91) is
to
9).
9).
9).
9).
6).
6).
TF 631
Advertisement
Table of Contents
