STEP 3
Secure the back of the Side Burner Assembly to the Firebox using 1 Phillips Head Bolt (A) and 1 Lock Washer
(C) in the lower hole of the Side Burner Back Bracket and tightening the Phillips Head Bolt (A) in the upper
hole.
STEP 4
Secure the front of the Side Burner Assembly to the Firebox using 1 Phillips Head Bolt (A) and 1 Lock
Washer (C) in the lower hole of the Side Burner Front Bracket and tightening the Phillips Head Bolt (A) in the
upper hole as shown. Then insert the Phillips Head Bolt that was removed from the lower side corner of the
Control Panel in Step 2 back into its hole and tighten.
Fig 1
10