Ssi-M Solid State Infinite Control With Manual Timer - Blodgett DFG-100 XCEL Installation And Operation Manual

Operation

SSI-M Solid State Infinite Control with Manual Timer

Figure 11
ContRoL DESCRiPtion
1. SELECTOR SWITCH - controls power to the oven for high
fan, low fan or cool down.
2. OVEN READY LIGHT - when lit indicates burner operation.
When the light goes out the oven has reached operating
temperature.
3. SOLID STATE THERMOSTAT - allows an infinite selection
of temperatures from 150-550ºF (66-288ºC).
4. TIMER - activates an electric buzzer that sounds when the
cook time expires.
5. LIGHTS SWITCH - controls interior lights.
6. RATE SWITCH - switches oven between standard rate
(60,000 BTU) and high rate (80,000 BTU) while in high fan.
NOTE: High rate is disabled with low fan.
7. GAS ON/OFF SWITCH - press to shut off gas to the oven.
oPERAtion
1. Turn the SELECTOR Switch (1) to either HIGH FAN or LOW
FAN. The blower and control compartment cooling fan op-
erate and are controlled automatically by the action of the
doors.
If high fan is chosen, high rate may be selected by toggling
the RATE SWITCH (6).
2. Set the SOLID STATE THERMOSTAT (3) to the desired set-
ting or temperature.
3. Preheat until the OVEN READY LIGHT (2) goes out.
4. Load product into the oven. Determine cook time and set
the TIMER (4).
5. When the buzzer sounds, remove the product from the
oven. Turn the TIMER knob (4) to OFF to silence the buzzer.
oven Cool Down:
1. Turn the SELECTOR Switch (1) to COOL DOWN.
NOTE: The doors may be opened to speed the cooling
process.
oven Shut Down:
1. Turn the SELECTOR SWITCH (1) to OVEN OFF.
WARninG!!
A complete five minute shutdown must be observed
before the oven is relighted.
16