Blodgett DFG-100 XCEL Installation And Operation Manual page 14

Installation
Gas Connection
GAS hoSE REStRAint
If the oven is mounted on casters, a commercial flexible
connector with a minimum of 3/4" (1.9 cm) inside diam-
eter must be used along with a quick connect device.
The restraint, supplied with the oven, must be used to limit
the movement of the unit so that no strain is placed upon
the flexible connector. With the restraint fully stretched the
connector should be easy to install and quick connect.
The restraint (ie: heavy gauge cable) should be 1,000 lb.
(453 kg) test load and should be attached without damag-
ing the building. DO NOT use the gas piping or electrical
conduit for the attachment of the permanent end of the
restraint! Use anchor bolts in concrete or cement block.
On wooden walls, drive hi test wood lag screws into the
studs of the wall.
5. Mount the supplied bracket to the leg bolt just below
the gas inlet.
6. Attach the clip on restraining cable to the mounting
bracket.
Restraint Cable
Bracket
Double stacked unit shown. Use the same procedure for single units.
Figure 10
Back of Oven
12
WARninG!!
if the restraint is disconnected for any rea-
son it must be reconnected when the oven is
returned to its original position.
U.S. and Canadian installations
The connector must comply with the Standard for Con-
nectors for Movable Gas Appliances, ANSI Z21.69VCSA
6.16 and a quick disconnect device that complies with the
Standard for Quick-Disconnect Devices for Use with Gas
Fuel, ANSI Z21.41VCSA 6.9. Adequate means must be
provided to limit the movement of the appliance without
depending on the connection and the quick disconnect
device or its associated piping.
Australia and general export installations
The restraint and quick connect must conform with Lo-
cal and National installation standards. Local installation
codes and/or requirements may vary. If you have any
questions regarding the proper installation and/or opera-
tion of your Blodgett oven, please contact your local dis-
tributor. If you do not have a local distributor, please call
the Blodgett Oven Company at 0011-802-658-6600