Gateway Solo 5100 Maintaining & Troubleshooting page 43

42 Maintaining and Troubleshooting Your Solo Notebook
5. Click OK to confirm that you want to remove the unknown device. Click
Close .
6. Place the usbsupp.exe driver disk in drive A.
7. Click , , then type:
Start Run
a:\ usbsupp.exe
then click OK .
8. Click
Yes on the next two windows if you want to continue with the
installation and you agree to the warranty terms.
9. When the USB drivers finish installing, remove the diskette. Click
restart.
10. The Update Device Driver Wizard appears. Click
11. Wait a few seconds for the Update Device Driver Wizard to find the drivers.
Click .
Finish
12. When Windows restarts, the
message that it is looking for file uhcd.sys. Redirect the path by typing:
C:\Windows\System
Click OK .
Redirecting the path in the Copying Files dialog box
13. Next you must install a USB update. Click
a:\ usbupd1.exe
click OK .
14. The Updating Windows
dialog box appears and displays a
Copying Files
Start
dialog box appears. Click
to
OK
Next .
, Run , then type:
Yes to continue.