Gateway Solo 5100 Maintaining & Troubleshooting page 42

Enabling USB ports
Your Gateway computer shipped with the USB ports enabled. However, if for some
reason you have to reload Windows, use the following instructions to reload the
USB driver supplement.
In addition, if you are adding a new USB device, you must load the USB device
driver according to the device manufacturer's instructions. If the Solo System CD
shipped with your system, you may use it to install the driver instead of installing
the drivers from diskette.
Enabling the USB ports for Windows 95
1. If not already installed, shut down and install the floppy drive module. Restart
Windows.
2. Click
Start , Settings
tab.
Device Manager
3. Under
Device Manager
Universal Serial Bus
Locating and removing the Unknown Devices
4. Click ?PCI Universal Serial Bus
, Control Panel . Double-click
tab click next to
+ Other Devices
in the list.
and click Remove
System icon and select the
. You will see
?PCI
.
Chapter 4: Installing Drivers and Related Software 41