Procedure 6.3 - Replacing The Lift Platform - Precor 9.25 Serveice Manual

Procedure 6.3 - Replacing the Lift Platform

WARNING
Always turn off the circuit breaker and unplug the treadmill before you remove the treadmill hood.
Removing the Lift Platform
1. Remove the hood.
2. Place the treadmill on its left side.
Note:
To avoid scratching or marring the treadmill, put a drop cloth underneath the treadmill when you
perform Step 2.
3. Remove the e-rings and lift pins that secure the lift motor nut to the lift platform.
Note:
It is not necessary to remove the lift motor when you remove the lift platform.
4. Remove the e-rings from the ends of the lift platform shaft. Slide the shaft away from the lift
platform and treadmill frame.
5. Remove the wheels from the lift platform. Mount the wheels on the new lift platform.
Replacing the Lift Platform
6. With the treadmill still on its left side, position the lift platform at its mounting position.
7. Slide the lift platform shaft into the lift platform and treadmill frame.
8. Replace the e-rings on the ends of the lift platform shaft.
9. Replace the e-rings and lift pins that secure the lift motor nut to the lift platform.
10. Return the treadmill to an upright position.
11. Check the operation of the treadmill as described in Section Three of this appendix, then
replace the hood.
9.25, 9.25i Treadmill
Page 29