Procedure 6.9 - Replacing The Lift Platform - Precor 9.45 Service Manual

Procedure 6.9 - Replacing the Lift Platform

Removing the Lift Platform
1. Turn off the treadmill with the circuit breaker, then unplug the power cord from the wall
outlet.
WARNING
Before continuing with this procedure, review the Warning and Caution statements listed in
Section One of the Residential Treadmill Service Manual.
2. Place the treadmill on its left side.
Note:
To avoid scratching or marring the treadmill, put a drop cloth underneath the treadmill when you
perform Step 2.
3. Remove the lower bolt and nut that secure the lift motor to the lift platform.
Note:
It is not necessary to remove the lift motor when you remove the lift platform.
4. on 1L units only, remove the bolt that connects the actuator block to the lift platform.
5. Remove the bolts and nuts that secure the lift platform to the treadmill frame (see Diagram
6.7).
9.45, 9.45i Treadmill
Page 50