Precor 9.25 Serveice Manual page 9

Procedure 2.4
This procedure resets accumulated user information and odometer readings for an individual
User ID. All previously-saved user information for a selected User ID will be either reset to zero or
changed to default values. The odometer reading for the selected User ID will be reset to zero.
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
With the PRECOR M9.25 or PRECOR M9.25i banner scrolling, press any key.
2.
At the User ID prompt, select the User IDs to be reset using the SPEED
3.
and SPEED (or INCLINE ) keys.
Press the STOP and QUICKSTART keys together and hold them for approximately two
4.
seconds (or until the right middle display window displays one of the numbers sets in
Procedure 2.2, step 3a, 3b, 3c or 3d).
5. If you do not observe the values listed in Procedure 2.2, step 3a, 3b, 3c or 3d...
THEN...
Replace the upper PCA as described in
Procedure 5.2 of the Residential Treadmill
Service Manual.
Note:
If the upper PCA is replaced, all user information will be re-initialized.
- Resetting an Individual User's Information
OTHERWISE...
This procedure is complete.
9.25, 9.25i Treadmill
(or INCLINE )
Page 9