Troubleshooting - Diamondback 910Ic Owner's Manual

Exit. To exit the setup mode, press the RESET key at any time.
Program End. Press the START-STOP key twice to end the program and return to the main screen.
Fitness Test
The 910Ic offers a pre-programmed test to provide a relative measurement of your
body's ability to recover from a strenuous workout. The program will monitor the
amount of time required for an elevated heart rate to return to normal. This comparison
provides a fast, simple gauge of how fit you are. If you exercise regularly, you will see your fitness
rating improve.
The Fitness Test requires a wireless heart rate signal. See the section above titled, "Using the
Wireless Heart Rate Receiver" for operation of this function.
During the program, you must remain relaxed and within three (3) feet of the console.
To launch the Fitness Test program, press the FIT TEST button on the keypad. A one-minute timer will begin to count down. Only
the countdown clock value and current heart rate will be displayed. When the program concludes, your relative fitness rating
will be displayed in the Matrix Display/Brickyard. The returned values range from F1 to F6. See the chart above. This rating is
only a guideline and not meant to serve as professional, medical or health information.
Press the START-STOP key to end the program and return to the main screen at any time.

TROUBLESHOOTING

Problem: The display will not light up.
Solutions: 1. Make sure wire harness connectors are connected. 2. Pedal at a speed exceeding 15 RPM.
Problem: The display powers on, but only Time function works.
Solution: Make sure wire harness connectors are connected..
Problem: Display segments for a functioning program are not visible, or an error messages appears.
Solutions: 1. Unplug the unit from the 120V power supply for fifteen (15) seconds, then reconnect. 2. Replace the electronic monitor.
910Ic Owner's Manual
29