Diamondback 910Ic Owner's Manual page 11

12

Insert the handlebar/stem assembly (B-21) into
the receiver on the main frame, paying care
not to pinch the wire harness connector (B-17).

Loosen the stem height adjuster knob (G-6)
with two or three counter-clockwise rotations.
Adjust the stem/handlebar assembly to the
lowest position by pulling outward on the knob
to disengage the pop-pin. If the stem assembly
does not drop, loosen the knob further and
pull outward on the knob again. Repeat these
steps again if necessary.

Install the saddle (L) onto the seat post and
tighten with the included wrench.

Install the pedals (F-L & F-R) onto the cranks by
threading the left pedal by hand (marked with
an "L") into the left crank with a counter-
clockwise rotation. Do not cross-thread the
cranks/pedals. The pedal must be tight and
installed completely to prevent future damage
to the cranks.

Repeat the pedal installation steps for the right
side, noting that the pedal will thread into the
right crank with a clockwise rotation.

Insert the water bottle (B-16) into the water
bottle cage.