Stiga Primo 2008 Workshop Manual page 25

Edition Manual
2008-03-18 Workshop Manual, Stiga Primo
6. Fit the threaded wire to the rear steering
lever.
Note!
Locate the wire as observed during the
dismantling.
Check that the wire not interface with
frame parts, rods, levers etc.
Mount the following parts:
• Spring (G)
• Nut (F). To facilitate the mounting of the
remaining steering pulleys, screw on the
nut a few turns only.
6. Mount the two pulleys at the left part of the
machine together with the wire.
See "3.1.4 Steering pulleys".
7.
Tighten the nut (F) and compress the spring
until its length is 108 mm. Hold the wire with
a pliers.
8. Turn the wheels fully out in both directions.
Check that there is no abnormal noise or
abnormal resistance.
Chapter
3 Steering
G
E
108 mm
Page
4
F
E